TEVO GlassGard is specifically formulated to benefit the car owner in numerous ways. It enhances the glass surface by providing hydrophobic properties to it and increase the visibility during heavy rain. With that, the result of maximum water spot reduction can be achieved as water bead rolls down upon contact with enhanced glass surface.
Physical : Clear Liquid (Solvent Based)
Colour : Transparent
Odour : Moderate
Finishing : Clear and ultra-smooth finishing
Durability : Up to 1 years
Coating Thickness : 1 – 2 Microns
Hardness : > 4 H
Contact Angle : > 100 degrees
Coverage : 200 m²/ Litre OR 30ml / 2 cars
Shelf Life : Sealed 12 months / Opened 1 month
Curing Time : 24 hours for surface drying/ 7 days fully care
Layer : Singer
Application : Apply and buff
Use TEVO Glass Degreaser to break down incurable scale and old wax that adhered to your glass surface. Rinse off the degreaser completely with water. Make sure the glass surface is completely dry before application.
Step 1 : (Preparation)
Soak the coating onto the application sponge or dry application tissue/towel. Apply small section at a time by dragging the coating horizontally (Left to Right) once and vertically (Top to Bottom) once. Make sure the coating covers every part of the glass surface.
Step 2 : (Scrubbing)
Immediately, use a microfiber cloth to buff the coated surface, do not pressurize the buffing process. Buff off completely until there is no visible striking or lining. (If you have hard time buffing off the striking and lining, recoat the particular surface again with step 1)
Step 3 : (Finish)
Wait for a minimum of 20 minutes for the coating to cure and bond with your glass surface; for best performance, allowing the coating to cure for 24 hours. Try to rinse through the surface with water and you will notice the amazing water beading and hydrophobicity results.